![]() Standard for flashing a micro-controller, nor is there a standardīootloader that works across all micro-controllers. It is typically used to flash a newĪpplication (eg, Klipper) to the micro-controller without requiring The bootloader is 3rd-party software that runs on the micro-controller If the Flash process fails or the command ls -l /dev/serial/by-id/* produces nothing meaningful then see: klipper Frequently asked questionsĪnd KevinOConnor/klipper/blob/master/docs/Bootloaders.md This document provides information on common bootloaders found on Loaded configuration '/home/ubuntu/klipper/.config' The process should look something like this: ~/klipper $ make menuconfig The Klipper log file ( /tmp/klippy.log) will tell you the expected cfg file name.Mainsail / MainsailOS already seems to create a basic cfg file.It is entirely your responsibility and a manual task to create the required file In the log file you will also see what the expected filename and location of the cfg is Restart the Klipper service: sudo service klipper restart.Create the cfg or append the existing cfg according to klipper/printer-wanhao-duplicator-9-2018.cfg at master. ![]() Depending on how you install Mainsail you should already have a bare minimal printer.cfg or mainsail.cfg (this is why I do not like these blackbox solutions, as it kind of invalidates the official documentation and the user does not know how to get to the required steps).This will flash the required firmware to your printer board
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |